IoT sensors
New features
Le partenaire pour la captation, transmission et mise à disposition de vos données
Discover all the new features of our sensors: TEMP, TEMP2S, PULSE, PULSE ATEX, DRY CONTACTS et COMFORT.
TEMP / TEMP2S
Timestamp
Network test at startup
Personalisation of the joint phase
PULSE / PULSE ATEX
Timestamp
Network test at startup
Personalisation of the joint phase
COMFORT
Timestamp
Network test at startup
Personalisation of the joint phase
Redundancy
Alarm repetition
DRY CONTACTS
Timestamp
Network test at startup
Personalisation of the joint phase
New frame of time counter
Adding a timer in the DL frame
Event threshold alarm
Additional information in the life frame
Understanding the sensor evolutions
TEMP, TEMP2S, PULSE, PULSE ATEX, COMFORT, DRY CONTACTS - LoRaWAN
timestamp
The frames now contain the date and time corresponding to the last recorded data.
personalisation of the join phase
Possibility to configure all the characteristics linked to the join phase (number of tries per attempt…).
network test at startup
During the join phase the sensor exchanges with the gateway and determines the quality of the radio link on site. The result of this test is given to the installer via the LEDs on the sensor.
COMFORT
alarm repeat
Any alarm triggered when a threshold is exceeded can now be repeated for a set period of time as long as it is active.
redundancy
Redundancy is a mechanism that allows data to be repeated from one frame to another. Thus, in case of frame loss, some information is recovered in the next frame, which reduces the risk of data loss and increases the overall reliability of the solution…
DRY CONTACTS
addition of a timer in the dl frame
The timer associated with the downlink frame can be used to configure a delay during which the change of state is applied to the output.
alarm on event threshold
In event mode, it is possible to set a number of events triggering the sending of the frame.
news in the life frame
The life frame now contains additional information:
- status of digital inputs
- counting of the number of frames sent: allows to validate the good reception of all the frames.
new frame of timer cunter
Adding a new frame to count the time spent in a state that is not the default state.
Ex:
For a door contact sensor, which counts the openings/closings, this frame makes it possible to count the time spent by the door in an open state.
For an equipment on which the sensor detects an operating stop, this frame allows to count the time spent in an active state.
Discover our entire range of IoT sensors to meet all your projects.
26/11/2020
20 years
expertise to support you, from the diagnosis to the implementation of your solution
